STERWINS ECS2-35.3 Manual De Instrucciones página 63

2. SAFETY INSTRUCTIONS
On a fallen tree, a rooted stump has a high potential of springing back to
3
0
the upright position during the bucking cut to separate the log from the
stump.
Watch out for spring poles, they are dangerous.
EN
Vibration and noise reduction
To reduce the impact of noise and vibration emission, limit the time of
operation, use low-vibration and low-noise operating modes as well as
wear personal protective equipment.
Take the following points into account to minimize the vibration and
noise exposure risks:
1.Only use the product as intended by its design and these instructions.
2.Ensure that the product is in good condition and well maintained.
3.Use correct application tools for the product and ensure they in good
condition.
4.Keep tight grip on the handles/grip surface.
5.Maintain this product in accordance with these instructions and keep it
well lubricated (where appropriate).
6.Plan your work schedule to spread any high vibration tool use across a
number of days.
Emergency
Always read this instruction manual thoroughly before the first use of the
product. Make sure you understand and apply all safety instructions.
1.Always be alert when using this product, so that you can recognise
and handle risks early. Fast intervention can prevent serious injury and
damage to property.
2.Switch off and disconnect from the power supply if there is any
malfunction. Have the product checked by a qualified specialist and
repaired, if necessary, before you put it into operation again.
62