Bosch PowerTube 500 Instrucciones De Servicio Originales página 17

❶ To insert the PowerTube battery, insert it into
the frame with the socket for the charging con-
nector (5) facing upwards until the battery clicks
into place. Ensure that the battery is aligned cor-
rectly.
❷ Close the locking mechanism (9), insert the
key (1) into the battery lock (2) and secure the
battery. Make sure that the safety hook (3) is
hooked in at the opening of the axial rail (11).
❸ Check that the battery is secure in all directions.
Always remove the key (1) from the lock (2) after
locking it. This prevents both the key from falling out
and the battery from being removed by unauthorized
third parties when the eBike is not in use.
Inserting and Removing the PowerPack battery
(see figure E)
E
(1)
(2)
(14)
(15)
(16)
In order to insert the battery, the key (1) must not be
inserted in the lock (2).
To insert the PowerPack battery (15), place it so that
its contacts are in the lower holder (16) on the eBike.
Tilt it into the upper holder (14) as far as possible un-
til you hear it click into place.
Check that the battery is secure in all directions.
Bosch eBike Systems
Do not ride with the key (1) inserted. Make sure that
the key is no longer inserted when you park the eBike.
To remove the PowerPack battery (15), switch it off
and open the lock (2) using the key (1).
Tilt the battery out of the upper holder (14) and pull it
out of the lower holder (16).
English – 15
0 275 U07 3PX | (08.06.2022)