Connecting Speakers - Esoteric S-05 Manual Del Usuario

Connecting speakers

Notes about speaker cables
o Use commercially-available speaker cables to connect the speakers.
o Use the shortest speaker cables possible. The longer the cable, the
greater the resistance value and the more that damping perfor-
mance is reduced. Moreover, length also increases inductance and
capacitance, degrading the sound quality of high frequencies.
o Use left and right speaker cables that have the same length.
How to connect speaker cables
Use commercially-available speaker cables to connect the + terminal
of the unit to the + terminal of the speaker and the − terminal of the
unit to the − terminal of the speaker.
o Use speakers with at least 4Ω impedance. When using BTL mode,
use speakers with at least 8Ω impedance.
o If the exposed tip of the core wire of a speaker cable contacts
another cord or terminal, a short could occur.
Never allow speaker cables to cause a short.
o Do not connect more than one amplifier to a speaker.
o Do not bundle speaker cables with power cords. Doing so could
cause noise.
V
The power plug should always be disconnected
when connecting speaker cables.
V
Precautions when connecting speaker cables
Connect the cables securely so that they do not become loose
and the core wires or terminals at their ends do not become
exposed and contact other metal parts or the unit.
10
When using bare speaker wires
Loosen the cap and insert the core wire into the hole in the terminal.
Then, tighten the cap.
When using spade connectors
Loosen the cap and insert the spade connector between the cap and
base of the terminal. Then, tighten the cap.
o When connecting speakers with spade connectors, they should
have inside diameters of at least 8 mm.
When using banana plugs
With the cap tightened, insert the plug into the opening in the end
of the terminal.
o Carefully read the instructions for the banana plugs that you are
using.
Notice about the European model
In accordance with European safety regulations, connecting
banana plugs to speaker terminals is not allowed on European
models.
The holes into which banana plugs could be inserted have been
covered with black caps. Connect speakers using bare wires or
spade connectors.
If a black cap should become separated from its terminal, return
it to its original position.