Getting Started; Filling Engine Oil - DJI D12000iE Guía De Usuario

USB-C Connector on the Generator

Getting Started

Filling Engine Oil

The generator has not been filled with engine oil before leaving the factory. It is necessary to add engine oil
before use.
Place the generator on a flat and stable surface, unscrew the dipstick, fill the engine with oil to the rated
capacity, and screw the dipstick back on. The D12000iE Multifunctional Inverter Generator has a rated engine
oil capacity of 1.1 L. Use SJ 10W-40 engine oil (or equivalent).
Refueling
Fuel is highly flammable and explosive. Strictly follow the instructions to use. Before refueling the generator,
power it off and wait until it has completely cooled down.
1. Loosen the fuel tank cap and refuel the fuel tank with the recommended type of fuel to the rated capacity
according the oil level gauge*. The D12000iE Multifunctional Inverter Generator has a rated fuel capacity
of 30 L.
2. Tighten the fuel tank cap after refuelling. Use a dry towel to wipe up if any fuel is spilled.
* For recommended fuel types for different countries and regions, refer to the Appendix section.
• DO NOT power on the generator before filling engine oil or gasoline. Otherwise, the electronic fuel pump may be
damaged.
• DO NOT overfill fuel. Spilling can lead to a fire or explosion.
• Using ethanol fuel may increase the fuel consumption.
Pre-Operation Checking
In order to ensure your safety and preserve the service life of the generator, take some time to check the
conditions of the generator before each operation. Make sure any issues or malfunctions have been resolved
before operation.
Before starting the pre-operation check, make sure the generator is placed on a stable place and the engine
switch is in the OFF position.
Common Check-Up Items
1. Check whether there is any spilled engine oil or fuel around or under the generator.
2. Remove any flammable materials in the surrounding area especially around the muffler and the fan hood.
3. Repair or replace any rusted, broken, damaged, deformed, or loosened parts.
4. Check whether the muffler shield and the fan hood have been securely installed in place and whether all the
nuts, bolts, and screws have been tightened.
USB-C Cable
USB-A Connector on the
Remote Controller
7