UFESA Palermo Manual De Instrucciones página 18

Make espresso coffee
1. Plug in and press the ON/OFF switch the indicator lamps , and are flas-
hing on and the machine starts to preheat. When the all indicator lamps stop blinking and
turns normal on, the preheating is completed and the machine enters the making coffee
or hot water mode.
2. Remove the funnel (20) by turning it in clockwise.
3. Add ground coffee to the steel mesh (18) with the measuring spoon (17). Then press the
grounded coffee tightly with the tamper.
4. Rotate the high-pressure funnel assembly counterclockwise from position to posi-
tion (must be tightened).
5. Put a cup under coffee outlet.
6. Touch the one-cup coffee switch , the machine starts pumping water, and coffee
flows out of the coffee nozzle.
7. The coffee machine automatically stops working (the light from Breathing light on to a
constant light), and the coffee is made at this time.
8. After the coffee is made, take out the high-pressure funnel assembly by rotating it cloc-
kwise, clean the coffee grounds in the filter in time, and rinse it with hot water.
9. When making a duble cup of coffee, use the double-cup coffee filter (19), touch the dou-
ble-cup coffee switch and the other steps are the same as single-cup coffee making.
Frothing milk/ making cappuccino
The steam knob:
The steam knob shown below is in the closed position. There are two working states when
the steam knob is turned on. When the machine is in coffee mode, the steam pipe gives hot
water. When the machine is in steam mode, the steam tube gives steam.
18