Standard Accessories - HIKOKI CB 3612DA Instrucciones De Manejo

English
Display panel
Remaining battery indicator switch
Remaining battery indicator lamp
Rubber cover
USB port
USB cable
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
CB3612DA: Cordless Band Saw
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive
2012/19/EU on waste electrical and electronic
equipment and its implementation in
accordance with national law, electric tools
that have reached the end of their life must
be collected separately and returned to an
environmentally compatible recycling facility.
Direct current
V Rated voltage
Switching ON
Switching OFF
Disconnect the battery
Tighten band saw blade
Loosen band slaw blade
Number of teeth/inch
Direction of band saw blade rotation
Lock
Unlock
Prohibited action
Battery
Lights ;
The battery remaining power is over 75%
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 3 seconds.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 320.
NOTE
Battery and battery charger are not included with this
product.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Cutting various types of soft steel materials including
conduit pipes, stainless steel pipes, lining steel pipes
and steel rods
○ Cutting nonferrous metal materials including power and
communication cables and aluminum window frames
○ Cutting plastic (thermoplastic material cannot be cut as
the band saw blade may become wedged in the material
which is prone to melting when heated by cutting friction
SPECIFICATIONS
1. Power tool
Model
Voltage
Standard
Mode (1-5)
No-load
speed
Auto Mode
(A)
Band Saw blade
dimensions
Round pipe
Max. sawing
dimension
Square pipe
Battery available for this
tool*
Weight**
* Existing batteries
series, etc.) cannot be used with this tool.
** According to EPTA-Procedure 01/2014
12
CB3612DA
36 V
1.0–3.2 m/s
(60 m/min – 195 m/min)
2.0 m/s
(120 m/min)
12.5 mm (W) × 0.5 mm (T) ×
1140 mm (L)
External diameter 120 mm
127 mm (W) × 120 mm (H)
Multi volt battery
7.5 kg (BSL36B18)
(BSL3660/3620/3626, BSL18xx