Standard Accessories - HIKOKI C 3606DPA Instrucciones De Manejo

SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
C3606DPA: Cordless Plunge Cut Saw
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Always wear hearing protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/EU
on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V
Rated voltage
n
No-load speed
0
Switching ON
Switching OFF
Disconnect the battery
Prohibited action
Battery
Lights ;
The battery remaining power is over 75%.
Lights ;
The battery remaining power is 50%–75%.
Lights ;
The battery remaining power is 25%–50%.
Lights ;
The battery remaining power is less than 25%.
Blinks ;
The battery remaining power is nearly empty.
Recharge the battery soonest possible.
Blinks ;
Output suspended due to high temperature.
Remove the battery from the tool and allow it to
fully cool down.
Blinks ;
Output suspended due to failure or malfunction.
The problem may be the battery so please
contact your dealer.
NOTE
To prevent the battery power consumption caused by
forgetting to turn off the LED light, the light goes off
automatically in about 2 minutes.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 315.
Standard accessories are subject to change without notice.
APPLICATIONS
The cordless plunge cut saw is suitable for sawing wood,
plastics and other similar materials. It must not be used for
sawing metals, except for thin aluminium sheets (thinner
than 2 mm) and aluminium-laminated wooden or composite
boards.
SPECIFICATIONS
1. Power tool
Model
Voltage
No-Load Speed
Cutting
Capacity
depth
Blade size
Max. blade angle
Battery available for this tool*
Weight**
* Existing batteries
series, etc.) cannot be used with this tool.
When using the AC/DC adapter, the performance of the
brake function varies by power source.
** According to EPTA-Procedure 01/2014
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
Electronic control
○ Soft-start
○ Overload protection
This protection feature cuts off the power to the motor
in the event of overloading of motor or a conspicuous
reduction in rotational speed during operation.
When the overload protection feature has been
activated, the motor may stop.
In this case, release the tool switch and eliminate causes
of overloading.
After that you can use it again.
○ Overheat protection
This protection feature cuts off the power to the motor
and stops the power tool in the event of overheating of
motor during operation.
When the overheat protection feature has been
activated, the motor may stop.
In this case, release the tool switch and cool it down in a
few minutes.
After that you can use it again.
○ Brake function
Brake activates when the trigger is off .
The performance of the brake function varies by power
source.
13
English
C3606DPA
36 V
2500–5200 min
0° 66 mm
45° 43 mm
165 mm (D)  20 mm (H)
-1°–46°
Multi volt battery
5.4 kg (BSL36B18)
(BSL3660/3620/3626, BSL18xx
-1