Installation - Rational iCombi Pro 20-1/1 Manual De Instalación Original

4 | Installation

Scope of delivery: Mobile base frame for
floor-mounted units [
1 Mobile base
frame with
castors
3 Rear bracket
5 Cable support
4 Installation
CAUTION
Risk of crushing when installing due to
the weight of the unit
Fingers, hands and feet can be crushed
and if the centre of mass is not
observed, the unit may tip over during
lifting and transport.
Wear appropriate protective
n
clothing when positioning the unit.
Only lift the unit at the intended
n
lifting points.
Use carrying aids, e.g. a carrying
n
strap.
Ensure an even weight distribution
n
of the unit.
Note the centre of mass of the unit.
n
NOTICE
Incorrect assembly, installation and
transport
Set up the unit as described in the
installation manual. Incorrect transport
or installation may damage the unit.
Note the information on the rating
plate in order to install the unit properly
and to avoid damage.
80.51.826_iCombi Pro-iCombi Classic_fGR SG _IM_V01_EU-west
Photo 01]:
2 Front bracket
4 Extension of wa-
ter connection
NOTICE
Damage to the connections due to
moving
Unplug all connections when the unit is
moved. After the work has been carried
out, reconnect them in accordance with
the instructions.
When the unit is returned to its original
position, realign it horizontally and
secure it against slippage.
Rolling option: Apply the parking
brakes.
Installing the mobile base frame for floor-
mounted units
a
The floor-mounted unit is switched off
and voltage free.
a
The media connections on the floor-
mounted unit are disconnected.
a
The unit is clean and free of fat.
a
The floor-mounted unit is no longer
on the pallet.
a
The accessory kit for the mobile base
frame for floor-mounted units is avail-
able [ Photo
1. Turn the feet to the maximum height
[ Photo 02].
2. Run the mobile base frame under the
floor-mounted unit [
3. Hand-tighten the unit at the rear of the
mobile base frame. To secure the unit
properly, use the brackets supplied
[ Photo 04].
4. Hand-tighten the unit at the front of
the mobile base frame. Use the brack-
ets supplied to properly fasten the
01].
Photo 03].
9 / 56
en