Basic Parameters - Roborock Q7 Manual Del Usuario

Mop Cloth
C7
* Clean after each use and replace every 3 to 6 months
C7-1—Remove the mop cloth from the
mopping module. Wash and air dry
the mop cloth.
Notes:
• After cleaning, always remove the mop cloth to prevent
dirty water from leaching back into the clean water tank.
• A dirty mop cloth will compromise the washing
performance. Clean it before use.
Filter Components
C8
* Replace them every 1 to 3 months
C8-1—Mop Attachment Slot
1. Move your finger along the notch to
remove each filter.
2. Insert new filter components and make
sure they are properly installed.
Note: To ensure cleaning performance, replace the filter
components every 1 to 3 months, depending on the water
quality and how often you use the robot.
Charging Contact Areas
C9
* Clean every month
Clean the charging contacts of the dock and
the robot with a soft, dry cloth.
Battery
The robot is equipped with a high-performance
lithium-ion rechargeable battery pack. To
maintain battery performance, keep the robot
charged during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
Environment
Protection Information
Removing the Battery
* The following information applies only when disposing of the
robot and should not be followed for day-to-day operations.
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution. Remove
the battery before disposing of this product
and hand it to a professional battery
recycling facility for centralized disposal.
1. Operate the robot without connecting to
the dock until it runs out of battery.
2. Turn off the robot.
3. Unscrew the battery cover.
4. Remove the battery cover.
5. Press the latch to pull out the battery
connector and remove the battery.
Notes:
• Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the dock.
• Remove the entire battery pack. Avoid damaging the
battery pack casing to avoid short-circuits or leakage of
hazardous substances.
• In the event of accidental contact with battery fluid, rinse
thoroughly with water and seek immediate medical care.
11

Basic Parameters

Robot
Model
Q400RR
14.4V/5200mAh lithium-
Battery
ion battery
Weight Approx. 3.2kg (7.05 lbs. )
Rated Input 20V
Charging Time < 6 hours
Note: The serial number is on a sticker on the underside of
the robot.
Charging Dock
Model CDZ11RR or CDZ12RR
Rated Power 28W
Rated Input 100-240V~
Rated Output 20V
Rated Frequency 50-60Hz
14.4V/5200mAh lithium-
Charging Battery
ion battery
1.2A
1.2A