Troublesooting - Dynascan RL-300 Manual De Instrucciones

13.- TROUBLESOOTING:

Problem
The transceiver does not turn ON.
Without voice prompt.
During the communication, the
sound is heard interrupted.
Communication distance becomes
short.
The transceiver cannot program by
computer.
Once these checks have been performed, if you still have problems with the
transceiver, consult your Authorized Technical Service.
Possible solution
>> The battery is exhausted. Recharge or replace
the battery pack.
>> Make sure if turn off the voice prompt.
>> Check the setting of wide/narrow band in all
transceiver of your user´s group.
>> Confirm whether it is close to the limit of the
communication range.
>> Check whether the squelch level is set too high.
>> Check that the antenna is installed correctly.
>> Check whether the squelch level is set too high.
>> Check whether the low transmission power is
selected.
>> Confirm whether the programming cable is
correctly plugged between the [MIC/SP] jack of the
transceiver and the computer.
>> Confirm that the computer port selected is
correct.
English - 15 -