Install The Antenna; Install The Belt Clip; Charging The Battery Pack - Dynascan RL-300 Manual De Instrucciones

7.2.- INSTALL THE ANTENNA:

Hold the bottom of the antenna, place on the transceiver connector and turn it clockwise
until stops. Turn counterclockwise to remove.

7.3.- INSTALL THE BELT CLIP:

Install the belt clip on the back of the transceiver as shown in the figure.

7.4.- CHARGING THE BATTERY PACK:

The battery is not fully charged after purchasing; please charge it completely before use.
1. Turn off the transceiver while charging the battery pack.
2. Connect the AC/DC adapter to the DC jack of the desktop battery charger.
3. Connect the AC/DC adapter to a nearby and easily accessible 230 VAC wall outlet,
the LED indicator will light green.
4. Insert the battery or transceiver with the battery into the desktop battery charger, the
LED indicator will light red, it means that the battery is charging mode.
5. It will need 4 hours approximately for fully charge the battery. When the charging is
English - 7 -