Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
26 INSTALLER SETTING
Function
Aircon
Primary Heater
O
AC. Fan Oper.
O
Interlocked With Vent.
Indoor unit Auto Start
O
Occupancy Duration
O
Time
CN-CC
O
CN-EXT
O
ODU Function Master
O
FAN Continuous
O
operation
Low noise mode priority
O
Lamp Color Setting
O
Dust Step Color Setting
O
Human Detection Sensor
O
Humidity Sensing
O
Position
ODU Cycle Priority
O
Outdoor Temp. For
O
Heating Stages
Estimated Energy
O
Display
CN-PTC
O
Temperature
O
Compensation
Product
Vent
When it is heating mode, the use of the heater
can be prioritized over the outdoor unit cycle to
increase efficiency.
It is a function to set the operation status of air
conditioner fan when the air conditioner is off,
in the interlock status of the ventilation product,
and when operating ventilation product.
In the event of a power outage, you can set
O
whether to recovery the product to its previous
operating state.
This function sets the minimum retention time
required for occupancy condition recognition
when using an occupancy sensor through dry
contact.
This function is used to set the usage of the
CN_CC port of the indoor unit.
This function determines the use of the CN_EXT
O
port of the indoor unit.
It is the function to set the outdoor unit's function
O
Master / Slave.
Fan operation of the indoor unit can be operated
longer than before to maximize cooling/heating
efficiency.
This function sets the object to prioritize low
O
noise mode.
This function selects the LED color to display the
fine dust status of the product.
You can change the color display method for
each stage of fine dust according to national
standards.
Set up detailed settings for using the human
body detection kit.
This function sets the position of humidity
detection.
This function sets the standby mode/ priority
cooling function usage setting and cooling
thermal off time when setting the priority cooling.
This function sets the standard of outdoor unit
cycle and heater operation according to outdoor
temperature conditions.
This function can set to display energy data
which outdoor unit estimated.
This is a function to select the use of CN-Port of
indoor unit.
You can display on the screen by applying offset
to the temperature value detected by the remote
controller.
Description
On / Off toggle
0 / 10 / 30 / 60 min
Automatic / Manual Uninstalled / Manual installed
• Not use: Use simple dry contact setting
• Simple operation: control Simple operation On/Off
• Single emergency stop: Indoor unit single
• Occupied / Unoccupied: Occupied / Unoccupied
• All emergency stop: Indoor unit all emergency stop
※ It can be set only when there is indoor unit
• Window contact: Window contact
※ It can be set only when there is window contact
• Window contact lock: Window contact with lock
※ It can be set only when there is window contact
Master / Slave.
On / Off
Outdoor unit / Remote controller
Automatic / RGB / YGG
Type1 : 4 Step(for Korea)
Type2 : 4 Step(for Global)
Type3 : 6 Step(for China)
Remote controller / Indoor unit
Not use
Standby Mode
Priority
On / Off
On / Off
-5 ˚C ~ +5 ˚C(0.5 degree unit)
-10 ˚F ~ 10 ˚F(1 degree unit)
Option
Off
Fan off
Extremely low wind
Not use
Reset to operation off
Reset to previous
state
operation state
emergency stop
emergency stop function.
function.
lock function.
Low
Use
Publicidad
Tabla de contenido
