Maintenance; Troubleshooting - Senix BLAE12-M Manual Del Operador

CONNECTING TO A POWER
SOURCE
Use only an extension cord recommended for outdoor use.
Insert the power plug of the blower into the extension cord.
Secure the extension cord to the appliance using the
molded in cord-lock feature (Fig. 3).
Plug the extension cord into the power supply.
USING THE BLOWER
Make sure the cruise control trigger at position 1 then
connect the blower to the power supply (Fig. 5).
Twist the cruise control trigger clockwise can switch on the
blower (Fig. 4).
Once the blower is on, continue to twist cruise control
trigger clockwise to increase the speed (Fig. 4).
When the trigger at position 2, the blower comes to the
maximun speed (Fig. 5).
Twist the cruise control trigger counterclockwise to speed
down till coming to a complete stop (Fig. 6).
OPERATING THE BLOWER
• To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the center
of a pile.
• To reduce sound levels, limit the number of pieces of
equipment used at any one time.
• Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when water
is available.
• Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches, and
gardens.
• Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
• After using blowers or other equipment, clean up. Dispose
of debris properly.

MAINTENANCE

WARNING:
In order to avoid personal injury and the risk of
fire and electric shock, disconnect the power
supply before adjusting, inspecting, or cleaning
the blower.
CLEANING
• Disconnect the power supply.
• Brush or blow dust and debris out of the air vents using
WWW.SENIXTOOLS.COM
compressed air or a vacuum. Keep the air vents free of
obstructions, sawdust, and wood chips. Do not sprays,
wash, or immerse the air vents in water.
• Wipe off the housing and the plastic components using a
moist, soft cloth. Do not use strong solvents or detergents
on the plastic housing or plastic components. Certain
household cleaners may cause damage, and may cause
a shock hazard.
STORAGE
Store the appliance and extension cord indoors, in a cool
dry location, out of reach of children and animals.

TROUBLESHOOTING

If you still have questions or an unresolved issue after going
through this troubleshooting guide, or just want to speak to
a Kobalt product expert, please call our Kobalt customer
service department at 800-261-3981.
POSSIBLE
PROBLEM
CAUSE
The blower will
Blocked tube
not blow.
Unplugged
power supply
The blower
doesn't start.
The switch is
defective.
SOLUTION
Clear the
blockage.
Plug in power
supply.
Have the switch
replaced by
an authorized
service center.
13 - EN