Starting Instructions; Maintenance - Senix BLB4QL-M Manual Del Operador

STARTING INSTRUCTIONS

1. Check the oil level before start. Add oil if need.
2. Fill the fuel tank. Refer to "FUELING THE UNIT".
3. Slowly press and release the primer bulb 10 times.
4. Turn on the on/off switch on the handle.
5. Move the choke lever up for closing the choke.
6. Crouch in the starting position. When pulling the recoil
starter rope, the operator and the unit must be in a
stable position.
7. Pull the recoil starter rope with a controlled and steady
motion 5 times until you can hear the deflagration of
engine.
8. Move the choke lever down to open the choke.
9. When the product starts, squeeze the throttle trigger to
increase engine speed. The more pressure you apply,
the faster it will run.
NOTE:
Use the throttle position lever which is intended for freeing
your finger from throttle trigger to maintain a certain blower
speed.
STOPPING INSTRUCTIONS
1. Release the throttle trigger and allow the engine to idle.
If the throttle position lever is used,turn it back and wait
the engine to slow down.
2. Press and hold the On/Off switch in the Off position until
the engine comes to a complete stop.
BLOWER INSTRUCTIONS
WARNING:
To prevent serious personal injury or damage to
the unit, do not hold the unit at your side. The
engine may be extremely hot. Do not block the
air intake.
• To reduce the risk of hearing loss associated with sound
level(s), hearing protection is required.
• To reduce the risk of injury associated with contacting
rotating parts, stop the engine before installing or
removing attachments. Do not operate without guard(s)
in place.
• To reduce the risk of injury associated with thrown
objects, always wear eye protection. Eye protection
should meet the requirements of ANSI Z87.1.
• To reduce the risk of injury associated with the inhalation
of dust, use a face filter mask in dusty conditions.
• Operate power equipment only at reasonable hours
not early in the morning or late at night when people
EN - 14
might be disturbed. Comply with times listed in local
ordinances. Usual recommendations are 9:00 a.m. to
5:00 p.m., Monday through Saturday.
• To reduce noise levels, limit the number of pieces of
equipment used at any one time.
• To reduce noise levels, operate power blowers at the
lowest possible throttle speed to do the job.
• Use rakes and brooms to loosen debris before blowing.
• In dusty conditions, slightly dampen surfaces when
water is available.
• Conserve water by using power blowers instead of
hoses for many lawn and garden applications, including
areas such as gutters, screens, patios, grills, porches,
and gardens.
• Watch out for children, pets, open windows, or freshly
washed cars. Blow debris away safely.
• Use the full blower pipe extension so the air stream can
work close to the ground.
• Keep feet apart and firmly planted.
• Hold the unit in front of, and away from, your body.
• Stand in the operating position. Stand up straight. Do
not bend over.
NOTE:
After using blowers and other equipment, CLEAN UP!
Dispose of debris in trash receptacles.

MAINTENANCE

WARNING:
To avoid serious personal injury, always stop the
engine and allow it to cool before cleaning or
maintaining the unit. Never perform cleaning or
maintenance while the unit is running. It is not
necessary to remove the blower tube assembly
during maintenance.
WARNING:
Wear protective clothing and observe all safety
instructions to prevent serious personal injury.
WARNING:
Use only original equipment manufacturer
replacement parts and accessories for this
unit. The use of any unauthorized parts or
accessories could lead to serious injury to the
user, or damage to the unit.
Only perform cleaning and maintenance work
according to these instructions! All further works
must be performed by a qualified specialist!
WWW.SENIXTOOLS.COM