Descargar Imprimir esta página

BH FITNESS G6540 Instrucciones De Montaje Y Utilización página 18

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is advisable for the assembly work.
Take the unit out of the box and place
it on the floor as shown in Fig.1.
Make sure that all of the pieces are
there: (1) Main structure; (18) Safety
key;
(106)
Bottle
Wrenches.
Follow the instructions step by step to
assemble:
1 Pull out the folding rod (39) from the
bottom of the running deck. Step on
the rod (39) with your foot and lift the
stand posts (9) upwards, Fig.2.
2 Hold the handlebar with one hand
and with the other lift the monitor tray
(55), Fig.3.
3 Finally place the monitor (58) in the
desired position, Fig.4.
4 LUBRICATION.-
CAUTION: Before the first use,
apply approximately half the bottle
of lubricant in the central part of the
belt, along the entire board, and on
both sides as shown in Fig.5.
An illustrative video about lubrication is
Fig.B
of
lubricant;
available on BH Youtube channel:
https://www.youtube.com/c/BHFitnessS
ervice/videos.
Important notes:
 If the bottle of lubricant is missing in
the box, please ask for it before
using an inappropriate lubricant.
 Pay special attention to lubricate the
area where you place your feet
during the exercise.
 After lubrication, start a program
without anybody using the machine
so
that
lubricates properly. If you lubricate
after exercise (the belt and the band
still warm), the lubrication will be
even better.
 Once the lubricant has been applied
you should neither fold nor use the
machine for a few hours. This will
allow
the
impregnated.
 If the belt starts to
lubrication, then check the tension
of the belt. To tension the belt, take
the 6mm Allen key and with the
machine set to 4km/h turn screws
(R & L) one turn in a clockwise
direction.
ATTENTION:
responsibility to periodically check
the lubrication level of the belt. To
do this, unplug the treadmill from
the electrical outlet; place one hand
between the belt and the surface of
the board to ensure that both
surfaces are lubricated, especially
in the area where you place your feet
during the exercise.
Please
note
maintenance
unsuitable products may lead to
loss of warranty.
18
the
belt
moves
belt
to
get
slip after
It
is
the
that
insufficient
or
the
use
and
well
user's
of

Publicidad

loading