Ecler CA120HZ Manual De Usuario página 61

XOVER_TYPE <Zone=ZA:ZD>
XOVER_FREQUENCY <Zone=ZA:ZD>
COMPRESSOR_ACTIVE <Zone=ZA:ZD>
COMPRESSOR_THRESHO <Zone=ZA:ZD>
LD
COMPRESSOR_RATIO <Zone=ZA:ZD>
COMPRESSOR_ATTACK <Zone=ZA:ZD>
COMPRESSOR_RELEASE <Zone=ZA:ZD>
COMPRESSOR_KNEE <Zone=ZA:ZD>
COMPRESSOR_GAIN <Zone=ZA:ZD>
DELAY_ACTIVE <Zone=ZA:ZD>
DELAY_TIME <Zone=ZA:ZD>
LP/HP
<Frequency=Hz>
ON/OFF
<Threshold=dBx10>
<Ratio=x100>
<AttackTime=msx10>
<ReleaseTime=msx10>
SOFT/HARD
<Gain=dBx10>
ON/OFF
<DelayTime=msx10>
61
Shows the current CROSSOVER FILTER TYPE (LP or HP) for the
specified output zone
Shows the current CROSSOVER FILTER FREQUENCY (Hz) for the
specified output zone
Shows the current COMPRESSOR status (ON or OFF) for the specified
output zone
Shows the current COMPRESSOR THRESHOLD LEVEL (dBx10) for
the specified output zone
Shows the current COMPRESSOR RATIO (x100) for the specified
output zone
Shows the current COMPRESSOR ATTACK TIME (milliseconds x10)
for the specified output zone
Shows the current COMPRESSOR RELEASE TIME (milliseconds x10)
for the specified output zone
Shows the current COMPRESSOR KNEE mode (SOFT or HARD) for
the specified output zone
Shows the current COMPRESSOR GAIN (dBx10) for the specified
output zone
Shows the current DELAY status (ON or OFF) for the specified output
zone
Shows the current DELAY TIME (milliseconds x10) for the specified
output zone