UFESA Bergamo Manual De Instrucciones página 23

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
or the connection between the power board and the display board is poor. Solution: Please
contact the special service center.
Make espresso coffee
1. Plug in and press the ON/OFF switch
, the single-cup coffee indicator, double-cup
coffee indicator flashes in red, the steam switch indicator is steady red, and the machine
starts to warm up. After preheating, the single-cup coffee indicator and double-cup coffee
indicator are always light on (white), the steam switch indicator light is always light on (red).
2. Remove the funnel (17) by turning it in clockwise.
3. Add ground coffee to the steel mesh (15) with the measuring spoon (14). Then press the
grounded coffee tightly with the tamper.
4. Rotate the high-pressure funnel assembly counterclockwise from position
to posi-
tion
(must be tightened). Put cup(s) under coffee outlet.
5. Touch the one cup coffee switch, the machine starts pumping water, and coffee flows
out of the coffee nozzle. The coffee machine stops automatically or you can press the
button again to stop working during the extraction process. During the extraction pro-
cess,
/
flashes(white). The buzzer beeps when the extraction is over, and the
indicator light turns to steady on white.
6. After the coffee is made, take out the high-pressure funnel assembly by rotating it cloc-
kwise, clean the coffee grounds in the filter in time, and rinse it with hot water.
7. When making a duble cup of coffee, use the double-cup coffee filter (16), touch the dou-
ble-cup coffee switch
and the other steps are the same as single-cup coffee making.
Frothing milk/ making cappuccino
The steam knob:
The steam knob is closed when the knob is pointing
. There are two working states
when the steam knob is turned on. When the machine is in coffee mode, the knob is turned
on and the steam pipe gives hot water. When the machine is in steam mode, turn the knob,
steam tube steam out.
Note: when the power is turned on, the steam preheating indicator keeps flashing fast (E-1
on the screen), which means that the steam knob is not closed, and you can turn the steam
knob to the closed position .
1. Prepare espresso first with a large enough cup according to part "MAKE ESPRESSO
COFFEE".
23

Publicidad

Tabla de contenido
loading

Tabla de contenido