Slime Garage Inflation Station Manual De Instrucciones página 4

TROUBLESHOOTING
Inflator does not turn ON:
1. Make sure plug is fully inserted into the wall outlet.
2. Make sure the outlet is live by using a known functional electronic device.
3. Check the fuse is located on the right side of the inflator. It may have blown. Unscrew
fuse cap, remove fuse and inspect. If necessary,
replace fuse with 2A 250V 5mm x 20mm.
Inflator runs but does not inflate:
1. Be sure the air hose valve connector is fully
secured on the tire valve.
2. Check tire for leaks, and check hose for breaks and leaks at fittings and check
valve core for damage.
3. Check to ensure the hose is not pinched or kinked as this will prevent air flow.
Inflator runs slowly:
1. The inflator may have overheated from excessive use. Shut it off and allow it to cool
for 25 minutes.
NOTE: If tire is totally deflated, it is possible that the tire could separate from the rim
allowing air to leak out when trying to inflate. In the event this occurs, you will have to
jack up the tire prior to inflation.
Dispose of this product at an e-waste recycling collection point or facility.
Do not place in the trash or standard recycling receptacle.
RATINGS: 120V AC, 60HZ, 1.0A, ON/OFF:5MIN/20MIN,
FOR WARRANTY INFORMATION GO TO: WWW.SLIME.COM / WARRANTY
QUESTIONS OR COMMENTS: Call (888)457-5463 or visit www.slime.com
ITW Global Tire Repair • 125 Venture Drive, Suite 210, San Luis Obispo, CA 93401 USA
Slime is a trademark of Illinois Tool Works, Inc., registered in the U.S. and other countries.
®
MAX. RATED PRESSURE 60PSI