Craftsman 247.88835 Manual Del Operador página 9

5. Re-tighten the hardware securing the chute crank bracket.
6. Check that the chute cables are properly routed through the cable
guide on top of engine shroud. See Figure 6.
Figure 4
Chute Crank
Bracket
Figure 5
Figure 6
ASSEMBLY
SET-UP
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins have been
included with your snow thrower. They are stored in the holes provided in the
plastic dash panel as seen in Figure 7. For information regarding replacing
the shear pins, see Replacing Shear Pins in the Operation section of this
manual.
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger housing
with a mounting clip and a cable tie at the factory. Cut the cable tie
before operating the snow thrower. See Fig. 8.
9
Figure 7
Clean-out Tool
Figure 8