Ashdown Engineering LITTLE BASTARD 2.N Manual Del Usuario página 12

LITTLE BASTARD 2.N
SPECIFICATIONS:
Inputs
High Input Impedance - 100k ohms
Low Input Impedance - 1M ohms
Effects Return Impedance - 1M ohms
Line Input Impedance - 22k ohms
Outputs
Effects Send Impedance - 47k ohms
D.I.Output 600 ohms balanced
Speaker Outputs Minimum Impedance - 4 and 8 ohms
Frequency Response -3db at 22hz and 25khz
Headphone Output 3.5mm Jack output @ 32Ohms
Equalisation
Bass +/- 15db @ 100hz
Lo-Mid +/- 15db @ 340hz
Hi-Mid +/- 15db @ 660hz
Treble +/- 15db @ 7khz shelving
Signal to Noise Better than 80db (E.Q. Flat)
Output Power 30watts into 4 or 8 ohms
USER GUIDE
Input range 300mv to 40v p - p
Input range 100mv to 10v p - p
Intrument level nominal
Input range 300mV
Instrument Level nominal
pre ground lift Level -20dbu nominal
LITTLE BASTARD 2.N
WARNING!
This product has been manufactured according to specific specifications with regard to supply
voltage requirements that are applicable to the country in which it is intended that this product be
If you have purchased this product via the internet or mail order you must verify that this product is
intended to be used in the country in which you reside.
The use of this product in any other country other than that for which it is intended could be
dangerous and invalidate the manufactures warranty.
Disposal of Old Electrical Equipment (Applicable in the European Union and other
European countries with separate collection systems).
This symbol on the product or on its packaging indicates that this product
shall not be treated as household waste. Instead it shall be handed over
to the appropriate collection point for the recycling of electrical and
electronic equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this product. The
recycling of materials will help to conserve natural resources. For more detailed info
about recycling this product, please contact your local Council, your household waste
disposal service or the shop where you purchased the product.
Notice for customer: the following information is only applicable to equipment sold in
countries applying EU directives
Manufacturer: Ashdown Engineering Ltd. The Old Maltings, Hall Road, Heybridge, Essex,
England, CM9 4NJ.
USER GUIDE
used.