Ashdown Engineering LITTLE BASTARD 2.N Manual Del Usuario página 4

LITTLE BASTARD 2.N
20.
9. 10.
9. MAINS INPUT
The amplifier is fitted with a standard IEC connector and supplied IEC lead correct
for the country in which you reside. The Pre-set input VOLTAGE is shown on the rear
panel together with fuse ratings.
10. MAINS
Power on and off with the switch provided once connected to the mains input
11. TORPEDO OUT
This is a balanced XLR DI output derived from the DynIR output.
USER GUIDE
19.
11. 12. 13. 14. 15. 16.
LITTLE BASTARD 2.N
12. HEADPHONES
There is a 32Ohm headphone out for use in silent practice. The headphone output
is derived from the amplifier output transformer and does not include the cabinet
simulation. This is intended for silent practice and monitoring in real-time.
13/14. SPEAKER OUTPUTS
Two speaker output sockets are provided at an impedance of 8 or 4 ohms only ONE
18.
must be used at any one time, the socket being chosen to match the impedance of
the cabinet combination in use at the time.
17.
The on board reactive load enables the amplifier to function without a load
connected.
15. TORPEDO LINE IN & DI LINK
The IR DI IN & DI LINK is an option that enables you the possibility of using the LB-
2.N as a re-amping unit to run your pre recorded lines giving them some alternative
tonal options with a number of alternative settings available via the embedded Two
notes Torpedo. The DI LINK push button links/unlinks the DIRECT DI and DynIR to
isolate the signal.
16. DIRECT DI
This is transformer derived from the output and as such will have all the adjustments
made with the tone controls, all effects in use and some influence from the speaker
in use. The level obtained is dependent on playing volume. But as a general rule is
suitable for line level (0,775V).
17. GROUND LIFT
A ground lift is fitted
18. MIDI IN/OUT
Midi IN and OUT sockets are provided to enable control via a midi controller
(available seperatly) over the available functions via the Two notes Torpedo. (See
MIDI for more info).
USER GUIDE