Backlight - auna Vertico Swing DAB Manual De Instrucciones

EN
34

Backlight

Under "BACKLIGHT" you can set the illumination of the display:
• Dim the display in standby mode after a certain time.
• Set the display brightness.
Setting the dimming time: select "Timeout" > "On" > "10" > "20" > "30"
> "45" > "60" > "90" > "120" > "180" seconds and press the "OK" button to
confirm.
Display brightness during operation: Select "On" and then the desired
setting: "High" > "Medium" > "Low". Confirm your selection with the "OK"
button.
Display brightness in standby mode: Select the "DIM" level and then
select the desired setting: "High" > "Medium" > "Low". Confirm your
selection with the "OK" button.
Language
• You can set the menu language under "LANGUAGE".
• In operating mode, press and hold the "MENU" button to access the
system settings. Use the "Forward" and "Backward" buttons on the
device (or the "Up" and "Down" buttons on the remote control to select
"LANGUAGE" and press the "OK" button to confirm.
• The following languages can be selected: English, French, German,
Italian, Norwegian, Polish, Portuguese, Spanish, Swedish, Turkish,
Danish, Dutch, Finnish.
Restoring factory settings
To restore the factory settings of the unit, please proceed as follows:
• In radio mode, press the MENU button until "System setting" appears
on the display. Press the "Forward" and "Backward" buttons on the
device (or the "Up" and "Down" buttons on the remote control) to select
the "FACTORY RESET" submenu.
• Press the "OK" button and confirm the following query with "YES".
• The unit is now reset to the factory settings, i.e. all alarm times, sleep
timer settings etc. are lost.
Software version
Press the "OK" button to display the system software version if required.