Backlight - auna Connect Vertical Manual Del Usuario

EN
58
Software update
1. During System settings mode, press
update and then press SELECT button to confirm.
2. Press / buttons to select Auto-check setting or Check now, and then
 
press SELECT button to confirm.
Note: Before downloading software, ensure that the radio is plugged into
a stable mains power connection. Interrupting the mains supply during
software download can lead to functional disturbances and/or damage to
the unit!
Setup Wizard
The setup wizard is available in the system settings section; you can run
through this to configure settings for date/time and network. Once this has
finished, your radio is ready to use.
Info
1. During System settings mode, press 12 / w / 3 / s buttons to select Info
and then press SELECT button to confirm.
2. The software version, Radio ID and Friendly name will show on the
display.
Privacy policy
To see the Privacy policy page, during System settings mode, press 12 /
w / 3 / s buttons to select Privacy policy and then press SELECT button to
confirm.
After Factory reset, you need to accept the Privacy policy again

Backlight

1. During System settings mode, press
and then press SELECT button to confirm.
2. For the other settings under Backlight, press 12 / w / 3 / s buttons to
select the following options and then press SELECT button to confirm.
Timeout
ON level ON level
DIM level
/ buttons to select Software
 
/ buttons to select Backlight
 
On / 10 sec / 20 sec / 30 sec / 45 sec / 60 sec /
90 sec / 120 sec / 180 sec
High / Medium / Low
Medium / Low