Important - Ascaso Steel Manual Del Usuario

ascaso
The installer must read this manual
closely before start-up.
The operator should be an adult and
fully competent person.
Should any anomaly occur, please
contact your distributor.
Start-up
1. Check that the voltage is the same
as that indicated on nameplate of
the machine.
2. Fill the water tank with fresh water
(see figure 1). Check that the
water inlet tube is immersed in
the tank.
NB! We recommend using water
with a low mineral content. The
quality of the water will affect the taste
and quality of your coffee as well as
help avoid future malfunctions. Check
out our especial anti-lime scale filters
(optional).
3. Make sure that there is enough
water in the tank. Running the
machine without water may
damage the pump. Water levels
should be checked visually.
To reduce the risk of injury, do
not drape cord over the counter
top or table top where it can pulle
don by children or tripped over
unintentionally.
32
MAN.38 V8 - MANUAL STEEL-STEEL PID 2022.indd 32 MAN.38 V8 - MANUAL STEEL-STEEL PID 2022.indd 32
UNO/DUO models. When turned
on for the first time, the machine
enters start-up mode. The pilot light
13
the machine heats up, until the right
temperature is reached. During this
process no service can be provided.
A.) Using the machine for the
first time or after a long interval.
Replacing the water in the circuit.
1. Turn the coffee maker on with the
2. Attach the empty filter holder
3. Press the coffee switch
B.) PRIMING.
• If no coffee comes out.
• After a period without use.
• After generating steam.
• If the tank has been emptied.
In the DUO model, repeat point A).
In the UNO model, the priming
procedure should be carried out:
1. With the coffee maker on, turn on
2. Turn on the water function
Figure 1
3. Turn off the water function
UNO model only
C.) After producing steam, wait
5 minutes before making coffee.
Or carry out the priming operation,
but let the water flow (point B2) until
the temperature pilot light
flashing.

IMPORTANT:

comes on and flashes while
6
general switch in position (I).
1
with a receptacle underneath.
approximately half a tank of clean
water flow through.
the steam tap .
4
and release some water (a cup)
through the steam wand
turn off the steam tap
coffee maker is now ready to use.
7
and let
2
14
.
5
and
14
. The
4
stops
6
06/09/2022 9:25:26 06/09/2022 9:25:26