Broan ADA HAWSK3 Instrucciones página 2

Only use included switches. Only use wires suitable for at least 90oC (194oF).
HIGH
Motor speed
selection
switch
(3-way)
LOW
HC0108
NOTES: 1.
If the HCK44 Power cord kit is used to connect the unit, install the provided ground screw (A)
on the unit grounding plate.
2. Use appropriate wire nuts for all connections.

Punch-out the other knock-out opening. Insert both 14/2 cable coming from
switches in the hood through an UL approved wire clamp. Connect BLACK wire
from house wiring cable to BLACK wire from no. 2 14/2 cable.

With a short ground wire (not provided), connect all ground wires together as
shown at right. Connect the other end of the short ground wire to the GREEN
ground screw.

Cap off the hood BLACK wire using an appropriate wire nut.

Connect WHITE wire from house wiring cable to both WHITE wires from hood.

Connect WHITE wire from no. 2 14/2 cable to BLUE wire (light).

Connect BLACK wire from no. 1 14/2 cable to ORANGE wire (high speed).

Connect WHITE wire from no. 1 14/2 cable to RED wire (low speed).
Once all the connections are done, reinstall the wiring compartment cover in the unit;
ensuring the bottom tabs are inserted in their embossed location. Secure in place
using its retaining screw
NOTE: Be careful while reinstalling the wiring cover to the hood.
Take care not to pinch wires while reinstalling wiring cover.
ON/OFF
Motor switch
ON/OFF
Light switch
OFF - ON
CAUTION
CAUTION
COM
Motor
speed selection
switch
HE0436A
Install 2 included rocker switches at a convenient place for the user.
Use two 14/2 cable to wire the switch box to the range hood (see
diagram above).
HO0412
2
WHITE
BLACK
WHITE
GROUND
NO. 1 NO. 2
14/2 CABLE 14/2 CABLE
TO HOOD TO HOOD
HD1371
5
6
4
7
HOUSE
WIRING
CABLE
NO. 1
14/2 CABLE
HE0439A
On/Off
motor switch
On/Off
light switch
A
2
1
NO. 2
14/2 CABLE
TABS