Black and Decker HD555 Manual De Instrucciones página 31

f Fit the threaded outer flange and tighten as explained
in 'Fitting the discs'.
Handy hints (Fig. E)
Hold your angle grinder firmly with one hand around the
side handle and the other around the body of your angle
grinder.
f Always position the guard so that as much of the
exposed disc as possible is pointing away from you.
f Be prepared for a stream of sparks when the disc
touches the metal.
When grinding, always maintain the correct angle between
the disc and the work surface (15°)(Fig. D). This increases
the removal capacity of the disc and avoids unnecessary
overloading.
Overload
Overloading will cause damage to the motor of your angle
grinder. This can happen if your angle grinder is subjected
to heavy duty use for prolonged periods of use. Do not in
any circumstances, attempt to exert too much pressure on
your angle grinder to speed up your work. The abrasive
discs operate more efficiently when a light pressure is
exerted, thus avoiding a drop in the speed of your angle
grinder.
MAINTENANCE
Keep guards, air vents and the motor housing as clear
as possible of dust and dirt. Wipe with a clean cloth and
blow through with a low-pressure air supply. Excessive
build-up of metal dust can cause tracking of electrical
current from the internal parts to exposed metal parts.
Do not overload your angle grinder. Overloading causes
a reduction in speed and efficiency, causing your angle
grinder to become too hot. If this happens, operate your
angle grinder under no load for one or two minutes until
it has cooled to normal operating temperature. Switching
your angle grinder off under load will reduce the life of the
switch.
CLEANING
Use only mild soap and a slightly damp cloth to clean your
angle grinder. Many household cleaners contain chemicals
which could seriously damage the plastic. Also, do not
use petrol, turpentine, lacquer or paint thinners or similar
products. Never let any liquid get inside the tool and never
immerse any part of the tool into liquid.
Important! To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment (other than those
listed in this manual) should be performed by authorized
service centers or other qualified service personnel,
always using identical replacement parts.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black & Decker
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned and
authorized service locations. All Black & Decker Service
Centers are staffed with trained personnel to provide
customers with efficient and reliable power tool service.
For more information about our authorized service centers
and if you need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker location
nearest you, or visit us at www.BlackandDecker-la.com
SPECIFICATIONS
Power
Disc diameter
Voltaje
AR
B2C
B3
B2
BR
No-load speed
Spindle size
Cable length
ENGLISH • 17
G720
820W
4-1/2" (115mm)
220V ~ 50Hz
220V ~ 50-60Hz
120V ~ 60Hz
220V ~ 60Hz
127V ~ 60Hz
11000/min
5/8"-11 / M14
2m