Troubleshooting - auna Oxford SE Manual De Instrucciones

TROUBLESHOOTING

No power
• Check the power plug connection at the wall socket.
• Short press the Power button to power on the Retro Turntable.
The tone arm skips grooves, slides over the record or does not move
• The Retro Turntable is not on a flat surface. Please move the product to
a flat and stable surface
• The record is dirty or scratched. Clean the record with a record cleaner
or play a different record.
The Turntable speed is incorrect
Select the correct speed according to the specification on the record. (33, 45
or 78 RPM).
No sound / Sound distortion
• Adjust the volume
• The stylus is dirty. Clean the stylus with a soft brush.
• The record is dirty or dusty. Clean the record with a record cleaner.
• Check that you are in the correct mode for the music that you wish to
listen to.
Retro Turntable powers off:
Your Retro Turntable has been designed to automatically go to Standby
mode after approximately 20 minutes without an audio signal, to save
power. Short press the Power button to turn the product back on again.
EN
51