Tabla de contenido
Publicidad
Renfert
12.1 Switch on the unit
The unit is ready to use.
The unit is filled and the objects to be cleaned have been inserted.
The unit is covered with the cover.
Press the On/Off button to switch on the unit. The display shows the last-used set-
tings, e.g. duration, ultrasound mode, current temperature and, if applicable, the
stored programme number.
Two modes can be selected for starting ultrasound operation:
Display in Normal mode
3
2
1
1. Set the duration, ultrasound mode and tem-
perature.
2. Switch the heating on/off.
3. Set the unit to start with auto-degas.
4. Or, set the unit to start with temperature con-
trol.
5. Save programmes.
Press the Mode button (1) for 2 seconds to switch between Programme mode and Normal mode.
The display (2) shows the current settings.
The display (3) shows the set programme number (programmes 1–4 in Programme mode).
12.2 Set the cleaning duration
From 1 minute to 6 hours.
Press one of the Plus/Minus buttons below the time display to set the duration.
Press the button repeatedly until the required duration is shown on the display. Hold
the button down to increase/decrease the duration more quickly.
Easyclean MD
Display in Programme mode
3
2
1
Select or start a saved programme.
12 Operating the unit
19 / 28
Publicidad
Tabla de contenido
