Save Programmes; Start A Saved Ultrasonic Cleaning Programme - Renfert Easyclean MD Traducción Del Manual De Instrucciones Original

12 Operating the unit

12.8 Save programmes

You can save up to 4 programmes.
Display in Save mode
3
2
1
To save the currently set programme, use the
plus/minus buttons to select a programme number
from 1 to 4.
In Normal mode the settings were made in the preset order. Switch on the unit [} 19] These settings
can be saved as a programme.
Important The auto-degas and temperature-controlled start modes can only be saved separately as in-
dividual programmes.
Hold down the Mode button (1) for >4 seconds until the display shows all 4 pro-
gramme numbers (3) and programme number 1 flashes. Now, press one of the Plus/
Minus buttons repeatedly until the programme number under which you wish to save
your settings flashes. Press the Mode button (1) again briefly to confirm saving the
programme. The saved programme number (4) will be shown on the display.

12.9 Start a saved ultrasonic cleaning programme

At least one programme from a possible four programme numbers has been saved.
The unit is in Programme mode. The last-used programme number is shown on the display.
The unit is in Normal mode. No programme number is shown on the display.
If necessary, switch between Normal mode and Programme mode. See Switch on the unit [} 19].
Hold down the Mode button until a programme number is shown on the display. The
last-used programme number is always shown, e.g. programme number 1.
Press one of the Plus/minus buttons to select a programme.
Press the Start/stop button to start the displayed programme.
22 / 28
Display in Programme mode
4
2
1
Renfert
Easyclean MD