Tabla de contenido
Publicidad
Renfert
Press the Start/Stop button to start the unit using the temperature-controlled start
function.
See the section Save programmes for information on saving the Temperature-con-
trolled start function as a programme.
The display shows the Temperature-controlled start and Heating symbols. The dis-
play shows the set target temperature and the current actual temperature of the
cleaning fluid flashing alternately.
During the heating phase, the ultrasound is switched on briefly multiple times to en-
sure that the fluid is heated evenly.
The ultrasonic cleaning function will start once the set target temperature has been
reached. The Temperature-controlled start symbol will disappear.
12.7 Start ultrasonic cleaning
The display shows the current settings.
For information on changing the settings, see Set cleaning duration, ultrasound mode and target
temperature.
The described settings have been configured and should be started.
If necessary, press the Heating button to heat the cleaning fluid. The Heating sym-
bol will be shown on the display. The display shows the set target temperature and
the current temperature of the cleaning fluid flashing alternately. If necessary, wait
until the target temperature has been reached.
Press the Start/stop button to begin ultrasound operation in the displayed mode.
The Remaining time symbol is shown on the display. The remaining time, the cur-
rent temperature and the set ultrasound mode are continuously shown on the dis-
play.
The ultrasound mode, temperature, duration and heating on/off can be changed
during ultrasonic cleaning. Important Changing the duration switches off ultrasonic
cleaning. Press the Start/stop button to restart ultrasonic cleaning with the altered
time setting.
The End of cleaning symbol and, where applicable, an acoustic signal (depending
on the configured parameters) indicate that cleaning has ended. The Remaining
time display will disappear.
Easyclean MD
12 Operating the unit
21 / 28
Publicidad
Tabla de contenido
