Safety Instructions; Charge The Battery - Würth POWERQUAD M AC/R Traducción Del Manual De Instrucciones De Servicio Original

Safety instructions

Do not open the lamp. There is a risk of a short circuit.
Note
It is forbidden to make any changes to the device. Such
changes can lead to personal injury and malfunctions.
Repairs to the unit may only be carried out by persons
authorised and trained for this purpose. Always use origi-
nal spare parts from Würth. This ensures that the safety of
the unit is maintained.
Use only genuine Würth accessories and spare
parts.
Operation
1 2 3 4 5
The luminous flux can be adjusted using the +/- button.
There are five brightness levels available for this purpose:
Level
5
10
20
50
100
The remaining running time in hours (h) is automatically
displayed for the respectively selected brightness setting!
100 100
50 80
20
60
10 40
5 20
6 7 8 9 10
Luminous flux
∼ 200 lm
∼ 400 lm
∼ 800 lm
∼ 2.000 lm
∼ 4.000 lm
Instructions for use
Operating modes:
Standing, Up to 90° set-up angle
Lying (Light emission Top)
Hanging (Hook or tripod
Attention!
Only connect to IPX4 sockets in splash water areas
Tripod mounting
One or two lamps can be mounted by means of
a mounting rail Art. 0981 180 591 On tripod
Art. 0981 100 1/0981 101 1
Note on the use of lamps with
-Labelling according to EN 60598-2-24
IP 4x
IP 5x
IP 6x

Charge the battery

•
Charge before first use. Charging time: 6-8 h
•
Remove protective cap.
•
Connect the power supply plug to the lamp.
•
The running light of the remaining time indicator lights up
during the charging process.
•
Charging is complete as soon as the battery capacity
is displayed as "100 %" and all LEDs of the remaining
time display light up.
Special features
•
At 10 % battery capacity, the light automatically dims to
the lowest brightness level (5 %). The luminous flux can
be adjusted upwards again using the +/- button.
Note
Simultaneous charging and lighting is possible with this
lamp. The lamp has integrated overcharge protection and
can remain permanently connected to the mains.
Note
Fully charge the fixture before storing it for an extended
period of time. Recharge the lamp regularly if it is not used
for a longer period of time.
mounting)
Environment without
dust accumulation
Environment with non-
electrically conductive
dust accumulation
Environment with
electrically conductive
dust accumulation
15