Installation Steps - Govee H610B Manual De Usuario

Installation Steps

1. Make sure the installation surface is dry and clean. Stick the mini level onto the designated
position on the positioning card, and remove the adhesive films of the positioning card.
Make sure the bubble of the mini bar is centered between the lines of the tube for the best
orientation. Then, stick the positioning card onto the surface.
2. Stick the control box to a suitable location.
3. Take one "A" segment and position the mini level on its side. Then plug the power clip
near to the control box into the end of the "A" segment and plug a "B" segment to the
other end. Align the assembled bar with the edge of the positioning card and make sure
the bubble of the mini level centers between the lines of the tube. Then remove the
adhesive film of the assembled bar and long press it for 5s to stick it onto the installation
surface.
04