Technical Data - Hilti TE 2 Manual De Instrucciones

4 Technical data

Note
When powered by a generator or transformer, the generator or transformer's power output must be at
least twice the rated input power shown on the rating plate of the electric tool. The operating voltage
of the transformer or generator must always be within +5% and -15% of the rated voltage of the
electric tool.
The information given applies to a rated voltage of 230 V. The data may vary in the event of deviations
from the rated voltage and for country-specific versions. Please refer to the electric tool's type
identification plate for details of its voltage, frequency, current and input power ratings.
Rated current input
Weight in accordance with
EPTA procedure 01/2003
Single impact energy in accor-
dance with EPTA procedure
05/2009
Drilling diameter range in con-
crete/masonry (hammer drill
bit)
Drilling diameter
range in wood (solid)
Drilling diameter
range in metal
(solid-head drill bit)
Maximum length of the depth
gauge
4.1 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one electric tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the electric
tool. However, if the electric tool is used for different applications, with different accessory tools, or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintain the tool and the accessories, keep the hands warm, organization of
work patterns.
Noise emission values in accordance with EN 60745:
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration (vector sum of three directions), measured in accordance with EN 60745-2-6 and EN
60745-2-1
Vibration emission value for rotary hammer drilling in
concrete (a )
h, HD
Vibration emission value for drilling in metal (a
Uncertainty for the given vibration value (K)
14
TE 2
3.0 A
2.7 kg
1.8 J
4 mm ... 22 mm
4 mm ... 20 mm
•/•
3 mm ... 13 mm
•/•
180 mm
)
WA
)
WA
)
pA
pA
TE 2-S
3.0 A
2.7 kg
1.8 J
4 mm ... 22 mm
4 mm ... 20 mm
•/•
3 mm ... 13 mm
•/•
180 mm
102 dB(A)
3 dB(A)
91 dB(A)
) 3 dB(A)
13.5 m/s²
) 2.8 m/s²
h, D
1.5 m/s²
TE 2­M
3.0 A
2.9 kg
1.8 J
4 mm ... 22 mm
10 mm ... 20 mm
4 mm ... 10 mm
8 mm ... 13 mm
3 mm ... 8 mm
180 mm