Technical Data; Core Bit Diameter; Use Of Extension Cords - Hilti DD 110-W Manual Del Usuario

3.4 TPS theft protection system (optional)
The product can be equipped with the optional TPS theft protection system. It can then be unlocked and
made ready for operation only through use of the corresponding TPS key.
4

Technical data

For rated voltage, rated current, frequency and/or input power, refer to the country-specific rating plate.
If the product is powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the product. The operating voltage of
the transformer or generator must always be within +5 % and -15 % of the rated voltage of the device.
Weight in accordance with EPTA procedure 01/2003
Weight
Speed
Dimensions (length x width x height)
Protection class
Permissible water supply pressure
Ambient temperature for operation
Storage temperature
4.1

Core bit diameter

Ø PCM core bits, dry
Ø HDM core bits, dry
Ø HWC core bits, wet
5

Use of extension cords

Using extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
*351007*
351007
1st gear
2nd gear
1st gear
42 mm ... 162 mm
(1.7 in ... 6.4 in)
102 mm ... 162 mm
(4.0 in ... 6.4 in)
122 mm ... 132 mm
(4.8 in ... 5.2 in)
5.7 kg
5.7 kg
(12.6 lb)
650 /min
1,380 /min
457 mm x 120 mm x
170 mm
(18.0 in x 4.7 in x
6.7 in)
I
≤ 6 bar
−17 ℃ ... 60 ℃
(1 ℉ ... 140 ℉)
−20 ℃ ... 70 ℃
(−4 ℉ ... 158 ℉)
2nd gear
•/•
16 mm ... 87 mm
(0.6 in ... 3.4 in)
25 mm ... 112 mm
(1.0 in ... 4.4 in)
English 7