Assembly - Truper TPN-734H-2K Manual

Assembly

Die Set Up
• Disconnect the tool from the air outlet before replacing
the die.
Nut or
• Select the die you need and set it in the box impeller.
Lug Inlet
• Always use impact dies with this tool. Do not use dies
for hand tools. Consult the catalog
to learn about our accessories variety.
Box Impeller
• Use 1/2" dies for box impellers.
Inlet
• Using adaptors for other sizes are not recommended.
Use only if strictly necessary.
• If the die has orifices always use rubber rings and steel
Impact Die
tips when setting it into de box impeller.
• When the box impeller is made with a retaining ring,
verify is in good repair. If damaged, replace immediately.
WARNING • When a die has not been secured and
adjusted as indicated, it can shoot out and injure the
operator.
Retaining
Ring
8
ENGLISH