Engine Oil Change; Air Filter - Zipper ZI-STE2000IV Instrucciones De Servicio

14.2.2

Engine oil change

Drain the used engine oil while it is still warm from operating the machine (drains easier).
14.2.3

Air filter

NOTE: Never operate the machine without or a not maintained air filter!
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Waste oils and fuel are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
• Loosen both screws (1) and remove the cover (2).
• Unscrew the dipstick (3).
• Drain the old oil into a suitable container.
• Fill in new engine oil and check the engine oil level with the
dipstick (regarding engine oil type and oil tank capacity see
technical data).
• If the oil level is correct, reinsert the dipstick (3).
• Remove oil residues with a cloth.
• Screw the cover (2) back on by using the two screws (1).
• Place the machine on an even surface and start the engine.
If there is sufficient engine oil filled in, the low oil alarm will be
not activated.
• Loosen both screws (1) and remove the cover (2).
• Loosen the screw (3) and remove the cover (4).
• Take out the air filter.
• Clean the air filter with soapy water, then rinse with clear
water and let it dry thoroughly before reassembling.
• The reassembly is done in reverse order.
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
N O TE
39
ZI-STE2000IV