Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. Line up the hole in the seat plate for seat adjustment
knob (A) with the hole in the seat.
5. Install and tighten the seat adjustment knob (A).
6. Tighten the seat adjustment knob (B).
To connect the battery
WARNING:
burn injuries. Do not use metal wristbands
or other metal accessories. Metal items that
touch the battery terminals can cause burn
injuries, electrical shock, and short circuit of
the battery.
Note:
If it is after the year and month that is written on
the battery label, charge the battery. Charge the battery
for a minimum of 1 hour at 6–10 A.
1. Find the battery location below the seat or the
engine cover.
2. Lift the seat pan or the engine cover to the raised
position.
3. Remove the 2 terminal caps (A) and discard them.
4. Connect the red battery cable to the positive (+)
terminal and tighten the bolt and nut as shown. Move
the terminal cover on the terminal.
WARNING:
battery cable must be connected to the
positive terminal before the black battery
cable is connected to the negative
terminal. This is to prevent sparks and
accidental grounding.
5. Connect the black cable to the negative (-) terminal
and tighten the bolt and nut fully.
6. Apply petroleum jelly on the battery cables to
prevent corrosion.
1932 - 004 - 13.10.2022
Risk of electrical shock and
A
Risk of sparks. The red
7. Lower the seat pan or the engine cover.
To move the product off the skid
1. Lift the cutting deck to its highest position. Use the
lift lever.
2. Push the clutch/brake pedal down to release the
parking brake.
3. Put the freewheel control in the "Transmission
disengaged" position, refer to
storage and disposal on page 33 .
4. Push the product forward off the skid.
5. Remove the strap that holds the deflector protection
up against the product.
To do a check after the assembly
•
Make sure that all assembly instructions are
completed.
•
Make sure that no remaining parts are in the
package.
•
Make sure that the battery is prepared and charged
correctly.
•
Make sure that the bolts for the seat are tightened
and that the seat is adjusted correctly.
•
Make sure that the tires are correctly inflated.
•
For best cutting results, make sure that the cutting
deck is balanced side to side and front to rear.
Make sure that the tires are correctly inflated for a
balanced cutting deck.
•
Examine the cutting deck and the drive belts. Make
sure that the drive belts are installed correctly
around the pulleys and inner part of all belt keepers.
•
Examine the electrical wires. Make sure that all wires
and connections are safe.
•
Make sure that the freewheel control is in
the "Transmission engaged" position. Refer to
Transportation on page 33 .
•
Make sure that the engine oil is at the correct level.
•
Make sure that the tank is filled with the correct type
of fuel.
•
Make sure that you know the location and function of
all controls.
•
Make sure that the brake system is in safe to
operate condition.
•
Make sure that the Operator Presence Control
(OPC) and the Reverse Operation System (ROS)
operate correctly. Refer to
operator presence control (OPC) on page 7 and To
do a check of the reverse operation system (ROS)
on page 7 .
•
Remove the air from the transmission before
To remove the air from the
first use. Refer to
transmission on page 28 .
Transportation,
To do a check of the
11
Publicidad
Tabla de contenido
Solución de problemas
