Transportation, Storage And Disposal - Husqvarna TS 242XD Manual De Usuario

Problem
The product moves slowly, with irreg-
ular speed or not at all.
The cutting result is unsatisfactory.
The engine backfires when the en-
gine stops.
The engine stops when you try to re-
verse.
Transportation
Note:
Close and attach the hood to the product during
transportation to prevent damage. Connect the hood to
the product with the correct tools (rope, cord and so on).
1932 - 004 - 13.10.2022
Cause
The product is in freewheel mode.
The parking brake is engaged.
The drive belt is loose or damaged.
There is air in the transmission.
There is unwanted materials on the
steering plate (if the steering plate is
installed).
The square key on the axle is miss-
ing.
The blades are blunt or damaged.
The cutting deck is not parallel.
The grass is wet.
The grass is long.
The tire pressure is incorrect.
The product is operated at too high
forward or rearward speed.
The drive belt for the cutting deck is
worn or damaged.
The throttle control is not put in the
slow position.
The reverse operation system (ROS)
is not engaged.

Transportation, storage and disposal

Action
Pull out the freewheel control lever.
To put the product in free-
Refer to
wheel mode on page 16 .
Disengage the parking brake.
Replace drive belt.
Remove the air from the transmis-
To remove the air from
sion. Refer to
the transmission on page 28 .
Clean the product.
Install the square key. Refer to
repair the tires on page 20 .
Sharpen the blades or replace the
blades.
Adjust the parallelism of the cutting
To adjust the parallel-
deck. Refer to
ism of the cutting deck on page 23 .
Let the grass become dry before you
cut it.
Start with a high cutting height and
decrease it gradually.
Do a check of the tire pressure. Ad-
just the tire pressure if it is necessa-
ry.
Use slower speed.
Replace the drive belt for the cutting
deck.
To stop the product on page
Refer to
14 .
Engage the reverse operation system
To use the reverse
(ROS). Refer to
operation system (ROS) on page 15 .
To
33