To Remove The Jumper Cables; Cutting Deck; To Adjust The Parallelism Of The Cutting Deck - Husqvarna TS 242XD Manual De Usuario

1. Connect one end of the red battery cable to the
POSITIVE (+) battery terminal (A) on the weak
battery.
B
A
2. Connect the other end of the red battery cable to the
POSITIVE (+) battery terminal (B) on the charged
battery.
WARNING:
the red battery cable touch the chassis.
This will cause a short circuit.
3. Connect one end of the black battery cable to the
NEGATIVE (-) battery terminal (C) on the charged
battery.
4. Connect the other end of the black battery cable to
a CHASSIS GROUND (D), away from the fuel tank
and the battery.

To remove the jumper cables

Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.

Cutting deck

To remove and install the cutting deck
Note:
If an accessory other than the cutting deck is
to be used, the front link and the rear lift links must be
removed from the product. Also, the clutch cable spring
must be put into the cable guide on the front edge of the
lower dash.
1. Disengage the cutting deck. Refer to
disengage the cutting deck on page 15 .
2. Stop the product. Refer to
page 14 .
3. Lower the cutting deck to the lowest position.
1932 - 004 - 13.10.2022
C
D
Do not let the ends of
To engage and
To stop the product on
4. Remove the mandrel cover (A).
A
F
G
F
G
5. Remove the drive belt from the clutch pulley (B).
6. Disconnect the front link (C) from the cutting deck
and remove the retainer spring and washer.
7. Remove the clips (D) and disconnect the suspension
arms (E) from the chassis pins.
8. Disconnect the rear lift links (F) from the rear cutting
deck brackets (G) on each side of the cutting deck.
9. Remove the cutting deck from the product.
10. Install the cutting deck in the opposite sequence.
Make sure that the grass discharge is on the right
side of the product.
Note:
The suspension arms must be in forward
position before you move the cutting deck below the
product.

To adjust the parallelism of the cutting deck

To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right and left
side of the product, the cutting height can be adjusted.
Adjust the cutting height on the side of cutting deck that
has the lower cutting height.
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
Some models only have left side
adjustment.
4. Adjust the cutting height with a 3/4" wrench.
E
B
C
D
A
A
23