Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not cut a wet lawn. Wet grass can give a bad
cutting result.
•
Do not use tire chains when you attach the cutting
deck to the product.
•
Make sure that the cutting deck is level. Refer to
adjust the parallelism of the cutting deck on page
23 .
•
If the grass is high, start with a high cutting height
and decrease it gradually.
•
Move the product forward at low speed if the grass is
high and thick.
•
Use full throttle when you cut the grass.
•
Cut the grass in an irregular pattern.
•
Use the left side of the cutting deck when you
cut near trees, bushes or paths. The blade cuts
approximately 15 mm in from the side of the cutting
deck.
•
When you cut large areas, move the product to the
right during 1 or 2 turns around the work area. This
procedure will keep the grass discharge away from
shrubs, fences and driveways. After approximately
2 turns around the work area, cut in the opposite
direction.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
16
To
Maintenance
Read and understand the
•
To get the best cutting result, cut the grass
frequently.
To put the product in freewheel mode
If it is necessary to move or tow the product without aid
from the engine, you must put the product in freewheel
mode.
WARNING:
freewheel mode on a slope.
•
Push in the freewheel control lever (A) to put the
product in freewheel mode.
A
•
Pull out the freewheel control lever to operate the
product with the engine.
Do not put the product in
1932 - 004 - 13.10.2022
Publicidad
Tabla de contenido
Solución de problemas
