Husqvarna TS 242XD Manual De Usuario página 24

Note:
Each full turn of lift adjustment nut changes
the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to lower
the cutting deck.
b) Turn the lift adjustment nut (A) to the right to lift
the cutting deck.
5. Cut some grass and examine the results. Adjust if it
is necessary.
To do a precision side to side adjustment of the cutting
deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 13 .
4. Turn the outer blade tips to align with the cutting
deck side to side.
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
5. Measure the distance (B) from the bottom edge of
the blade to the ground on the left and right side.
B
Note:
The distance must be the same on the 2
sides.
6. Adjust the cutting height with a 3/4 in wrench.
Note:
Each full turn of the lift adjustment nut
changes the cutting height with 3/16 in (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to lower
the cutting deck.
b) Turn the lift adjustment nut (A) to the right to lift
the cutting deck.
7. Measure the distance again. Adjust until the 2 sides
are equal.
24
The blades on the
B
A
8. Cut some grass and examine the results. Adjust if it
is necessary.
To do front to rear adjustment of the cutting deck
The cutting deck must be level side to side before you
do front to rear adjustment. Refer to
to side adjustment of the cutting deck on page 23 .
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in transport position. Refer to
To set the cutting deck in transport position or mow
position on page 13 .
4. Turn the blades until they point straight forward.
WARNING:
cutting deck are sharp and can cause
injury. Use protective gloves.
5. Measure the distance to the ground at the rear (A)
and front (B) end of the blade.
A
Note:
To get the best cutting results, the blades
must be adjusted until the front end is 1/8–1/2 in
(3.1–12.7 mm) lower than the rear end when the
cutting deck is in the highest position.
6. Go to the front of the product to make an adjustment.
7. Use a 11/16 in wrench to loosen the jam nut (C) to
clear the lift adjustment nut (D).
8. Adjust the cutting deck height with a 3/4 in wrench.
Note:
Each full turn of the lift adjustment nut
changes the cutting deck height 1/8 in (3.1 mm).
a) Turn the lift adjustment nut counterclockwise to
lower the cutting deck.
To do a visual side
The blades on the
B
D
C
1932 - 004 - 13.10.2022