To Change The Engine Oil - Husqvarna TS 248XD Manual De Usuario

1. Park the product in level ground.
2. Remove the oil fill cap and dipstick and clean it with
a cloth.
3. Put the dipstick into the oil fill tube. Do not turn the
oil fill cap onto the oil fill tube.
4. Remove the dipstick. Use the gauge on the dipstick
to examine the engine oil level. If necessary, fill
engine oil until the mark "FULL" on the dipstick is
reached. Do not fill too much engine oil.
ADD
5. Put the dipstick into the oil fill tube. Make sure that
the oil fill cap is fully tightened.
Note:
To replace the engine oil, Refer to
the engine oil on page 28 .

To change the engine oil

Note:
All oil must meet API service classification SJ-
SN.
Note:
Oil drains more freely when the engine is warm.
Make sure the product is on a level surface before you
chain the engine oil. Set the possible temperature range
before the oil change.
Collect the oil in an applicable container.
1. Lift the hood.
2. Remove the fastener (A) from the lower dash cover
(B).
B
A
CAUTION:
cover (A) carefully to make sure the
cover tabs (C) are not broken.
3. Move the lower dash cover (B) to release the cover
tabs (C) from the tapered slots (D) in the lower dash
cover (B) and then remove.
4. Remove the oil fill cap and dipstick.
28
CAUTION - DO
FULL
To change
C
Remove the lower dash
5. Install the drain tube (E) onto the oil drain valve.
F
01341
6. Turn the valve counterclockwise with a 10 mm
wrench to open the oil drain valve (F).
7. Turn the drain valve clockwise to close it (G) when
the oil is drained.
Note:
quantity of torque to keep the drain valve closed. Do
not tighten too firmly.
8. Remove the drain tube (E) and keep it.
9. Fill the engine with new oil through the oil fill dipstick
tube.
Note:
the engine with too much oil. For the approximate
capacity, see
10. Use the gauge on the oil fill dipstick to do a check of
the oil level.
a) Put the dipstick into the tube and let the oil fill
cap touch the top of the tube.
b) Do not tighten the cap onto the tube when you do
an oil level check.
D
c) Make sure the oil is at the "FULL" line on the
dipstick.
d) Tighten the cap onto the tube tightly when you
complete the check.
To replace the engine oil filter
WARNING:
you spill engine oil on your body, clean with
soap and water.
1. Drain the engine oil from the oil tank. Refer to
change the engine oil on page 28 .
2. Turn the engine oil filter counterclockwise to remove
it.
CAUTION:
Be careful not to let dirt
enter the engine when you change the
oil.
G
Use a 10 mm wrench to apply a small
Put oil into the engine slowly. Do not fill
Technical data on page 36 .
Use protective gloves. If
1931 - 004 - 13.10.2022
E
To