Husqvarna TS 248XD Manual De Usuario página 31

Problem
The starter motor does not turn the
engine over.
The engine does not run smoothly.
1931 - 004 - 13.10.2022
Cause
The battery is too weak.
The attachment clutch control is en-
gaged.
The clutch/brake pedal is not pushed
down fully.
The connection at the cable connec-
tors on the battery terminals is bad.
The main fuse is defective.
The ignition lock is defective.
The safety connector for clutch/brake
pedal is defective.
The starter motor or the solenoid is
defective.
The operator presence control (OPC)
is defective.
The spark plug is defective.
The carburetor is not adjusted cor-
rectly.
The air filter is dirty.
The check valve on the fuel tank cap
is defective.
The fuel tank is almost empty.
There is water in the fuel.
The choke is engaged and the en-
gine is warm.
The fuel mix or fuel type is incorrect.
The fuel filter is clogged
The spark plug is defective.
There is dirt in the carburetor or fuel
line.
Action
Charge the battery.
Disengage the attachment clutch
control.
Push down the clutch/brake pedal
fully when you start the engine.
Do a check of the battery connec-
tions.
Replace the main fuse.
Speak to an approved service agent.
Speak to an approved service agent.
Speak to an approved service agent.
Do a check of the wires, switches
and connections. If not corrected,
speak to an approved service agent.
Do not operate product with a defec-
tive operator presence control.
Replace the spark plug.
Speak to an approved service agent.
Clean or replace the air filter.
Replace the fuel tank cap.
Fill the fuel tank with fuel.
Remove all fuel from the fuel tank
and the carburetor. Fill the fuel tank
with new fuel and replace the fuel fil-
ter.
Disengage the choke.
Remove all fuel from the fuel tank
and the carburetor. Fill the fuel tank
with the correct fuel mix or fuel type.
Replace the fuel filter.
Replace the spark plug.
Clean the carburetor and fuel lines.
31