To Clean The Product - Husqvarna TS 248XD Manual De Usuario

A
A
A
A. General lubrication. Lubricate the spindle grease
connection, front wheel bearing, gear teeth of the
steering part.
B. Engine lubrication. Refer to
on page 27 .
Tractor

To clean the product

Do not use a garden hose or a pressure washer to clean
the surface except for the washout port. Keep water out
of the engine and transmission. Water in the engine or
transmission can decrease the life of the product. Use
compressed air or a leaf blower to remove grass, leaves
and litter.
• Clean all unwanted material from the engine, battery,
seat and other parts of the product.
• Clean contamination from the steering plate.
Contamination limits the movement of the clutch/
brake pedal shaft, causes the belt to loosen and
decreases forward movement.
CAUTION:
and movable parts.
• Keep the surfaces and wheels free of all gasoline,
oil, and so on.
• Use automotive type wax to prevent damage to the
surfaces.
To use the deck washout port
WARNING:
all holes in the mower.
WARNING:
missing washout port immediately before
you use the mower.
1931 - 004 - 13.10.2022
A
A
B
To lubricate the engine
Avoid all pinch points
Install bolts and locknuts in
Replace the broken or
WARNING:
washout port causes injury to you or others
by thrown objects if they touch the blade.
The product has a washout port as a part of the deck
washout system. Use it after each operation.
A
B
C
1. Move the product to a level, clear area near a
garden hose (A) connected to a water outlet.
CAUTION:
chute is far away from buildings, parked
vehicles and other items of value.
Remove the collector chute or mulch
cover if necessary.
2. Make sure the attachment clutch control is in the
"DISENGAGED" position. Engage the parking brake
and stop the engine.
3. Put the nozzle adapter (B) onto the end of the
garden hose (A).
4. Install the nozzle adapter (B) onto the washout port
(C) at the left end of the mower deck. Release the
lock collar and lock the nozzle adapter (B) on the
washout port (C).
CAUTION:
make sure the connection is safe.
5. Turn the water on.
6. Sit in the operator seat. Start the engine and put the
throttle lever in the "Fast" position.
CAUTION:
clear and no children are in the area
when you clean the deck.
7. Move the attachment clutch control to the
"ENGAGED" position. Stay in the operator seat with
the cutting deck engaged until the deck is clean.
8. Move the attachment clutch control to the
"DISENGAGED" position. Turn the ignition key to the
STOP position to turn the engine off. Turn the water
off.
9. Release the lock collar to disconnect the nozzle
adapter (B) from the washout port (C).
A broken or missing
Make sure the discharge
Pull the hose (A) to
Make sure the area is
19