To Connect The Jumper Cables - Husqvarna TS 248XD Manual De Usuario

c) Carefully install the belt below around the
transmission cooling fan and onto the input
pulley (F). Make sure the belt is in the belt
keeper.
d) Install the belt on the centerspan idler (E).
e) Install the belt through the stationary idler (C)
and clutching idler (D).
f) Install the anti-rotation link (B) on the right side of
the product and tighten fully.
g) Connect the clutch harness (A).
h) Make sure the belt is in all pulley grooves and in
all belt guides and keepers.
i) Install the mower. See
on page 23
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove the
battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with a
wire brush.
6. Lubricate the terminals with grease or equivalent.
7. Install the battery. Refer to
page 22 .
To replace the battery
The battery is installed below the seat.
WARNING:
burn injuries. Do not use metal wristbands
or other metal accessories. Metal items that
touch the battery terminals can cause burn
injuries, electrical shock, and short circuit of
the battery.
1. Stop the product. Refer to
page 14 .
2. Open the engine cover.
22
To install the mower deck
To replace the battery on
Risk of electrical shock and
To stop the product on
3. Remove the terminal covers (A).
A
4. Remove the bolt and the nut to disconnect the
black (negative) battery cable from the negative (-)
terminal.
WARNING:
and burn injuries. The black (negative)
battery cable must be disconnected
before you disconnect the red (positive)
battery cable.
5. Remove the bolt and the nut to disconnect the red
(positive) battery cable from the positive (+) terminal.
6. Carefully remove the battery from the product.
7. Install a new battery.
8. Connect the red (positive) battery cable to the
positive (+) terminal and tighten the bolt and the nut.
WARNING:
and burn injuries. The red (positive)
battery cable must be connected to the
positive (+) terminal before the black
(negative) battery cable is connected to
the negative (-) terminal to prevent injury
and accidental grounding.
9. Connect the black (negative) battery cable to the
negative (-) terminal and tighten the bolt and the nut.
10. Install the terminal covers.
11. Close the engine cover.

To connect the jumper cables

WARNING:
of explosive gas that comes from the
battery. Do not connect the negative
terminal of the charged battery to or near the
negative terminal of the weak battery.
CAUTION:
your product to start other vehicles.
Risk of electrical shock
Risk of electrical shock
Risk of explosion because
Do not use the battery of
1931 - 004 - 13.10.2022