Troubleshooting - Husqvarna TS 248XD Manual De Usuario

Note:
During this procedure, there can be
movement of the drive wheels.
a) Push the forward drive pedal to the full forward
position and keep it pushed down for 5 seconds
before you release it.
b) Push the reverse drive pedal to the full reverse
position and keep it pushed down for 5 seconds
before you release it.
6. Stop the engine and engage the parking brake.
Problem
The engine does not start.
30
7. Put the freewheel control in the engaged position.
8. Sit in the seat and start the engine. When the engine
9. Disengage the parking brake.
10. Operate the product forward for approximately 5

Troubleshooting

Cause
There is no fuel in the fuel tank.
The throttle control is not in the cor-
rect position.
The spark plug is defective.
The air filter is dirty.
The fuel filter is clogged.
There is water in the fuel.
The wires are loose or damaged.
The engine valves are not adjusted
correctly.
The engine is flooded.
The fuel in the fuel tank is bad.
To put the product in freewheel mode on
Refer to
page 16 .
has started, move the throttle control to the half
speed position.
ft (1.5 m) then rearward for 5 ft (1.5 m). Do this
procedure 3 times.
Action
Fill the fuel tank.
Refer to the start instructions.
Replace the spark plug.
Clean or replace the air filter.
Replace the fuel filter.
Remove all fuel from the fuel tank
and the carburetor. Fill the fuel tank
with new fuel and replace the fuel fil-
ter.
Do a check of all wires.
Speak to an approved service agent.
Wait 2–3 minutes before you try to
start the engine again.
Replace the fuel in the fuel tank.
1931 - 004 - 13.10.2022