Starting A Wash Program - Sunbeam Products Oster OS-DWG12SS Manual De Instrucciones

STARTING A WASHING PROGRAM
Wash cycle table
EN 50242: this program is the test cycle.
The information for comparability test in accordance with EN 50242, as follows:
Capacity:14 settings
Position of upper basket: Low position
Rinse aid setting:5(or 4 for four setting dispensers
Turning on the Appliance
Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and push them back. It is recommended
to load the lower basket first, then the upper one (see the section entitled "Loading the
dishwasher"). Pour in the detergent (see the section entitled "Detergent and Rinse Aid").
Insert the plug into the socket. The power supply is 110-127V AC 60 Hz, the specification of
the socket is 13 A 110-127 V AC.60 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press the "Power"
button,
Press the "Program" button to select a desired "Wash cycle". (See the section entitled "Wash
Cycle Table"). With a little force to ensure the door is properly closed.
NOTE: A click could be heard when the door is closed perfectly. When the washing is over, you
can shut off the switch by pressing "Power" button.
NOTE: If all the lights begin to glimmer, that indicates the machine is out of order, please turn off
the main power and water supply before calling a service.
English-13