Sunbeam Products Oster OS-DWG12SS Manual De Instrucciones página 42

Otherwise, the filters could be contorted, and the performance of dishwasher could be debased.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm
jets and bearings.
To remove the spray arms, screw off the nut clockwise to take out the washer on top of the spray
arm and remove the arm. Wash the arms in soapy and warm water and use a soft brush to clean
the jets. Replace them after rinsing thoroughly.
Caring for the Dishwasher
To clean the control panel, use a lightly dampened cloth then dry thoroughly.
To clean the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Protect Against Freezing
If your dishwasher is left in an unheated place during the winter, ask a service technical to:
1.Cut off electrical power to the dishwasher.
2.Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
4.Reconnect the water inlet pipe to the water valve.
5.Remove the filter in the tub and the bottom and use a sponge to use up water in sump.
Cleaning the Door
To clean the edge around the door, you should use only a soft warm, damp rag. To prevent
penetration of water into the door lock and electrical components, do not use a spray cleaner of
any kind.
Also, never use abrasive cleaners or scouring pads on the outer surfaces because they will scratch
the finish. Some papers towels can also scratch or leave marks on the surface.
WARNING!
Never use a spray cleaner to clean the door panel for it could damage the door lock and electrical
components. It is not allowed to use the abrasive agent or some paper towel because of the risk of
scratching or leaving spots on the stainless-steel surface.
How to Keep Your Dishwasher in Shape
After Every Wash
After every wash, turn off the water supply to the appliance and leave the door slightly ajar so that
moisture and odors are not trapped inside.
Remove the Plug Before cleaning or performing maintenance, always remove the plug from
the socket. Do not run risks.
No Solvents or Abrasive Cleaning to clean the exterior and rubber parts of the dishwasher, do not
use solvents or abrasive cleaning products. Use only a cloth and warm soapy water. To remove
spots or stains from the surface of the interior, use a cloth dampened with water and a little white
vinegar, or a cleaning product made specifically for dishwashers.
Attention:
The installation of the pipes and electrical equipment's should be done by professionals.
English-16