Positioning The Appliance - Sunbeam Products Oster OS-DWG12SS Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connect the cold-water supply hose to a threaded 3/4(inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used for an extended period, let the water run to make
sure that the water is clear and free of impurities. If this precaution is not taken, there is a risk that
the water inlet can get blocked, and the appliance could be damaged.
Fit the drainage hose of your machine to the drainage pipe without bending.
If the length of the hose is not sufficient, apply to the authorized service for an extension made from
the same material as the original. Remember that the length of the hose should not exceed 4meters
even when with an extension.
If the drainage hose is longer the 4 m. the dishes will not be cleaned properly secure your hose
firmly to the drainage pipe to avoid it coming off during the washing process.
Once the appliance has been installed, the power supply cable and the electrical socket should be
easily accessible.
The cable should not be bent or compressed.
If the power supply cable is damaged, it must be replaced by the manufacturer or its Technical
Assistance Service in order to prevent all potential hazards. (See Assistance)
The company shall not be held responsible for any incidents that occur if these regulations are not
observed.
Advice regarding the first wash cycle
After the appliance has been installed, immediately before running the first wash cycle, completely
fill the rinse aid dispenser (see Rinse aid).

Positioning the Appliance

Position the appliance in the desired location. The back should rest against the wall behind it, and
the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and
drain hoses that can be positioned to the right or the left to facilitate proper installation.
Leveling the Appliance
Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the height of
the dishwasher, making it level. In any case, the appliance should not be inclined more than 2°.
English-19

Publicidad

Tabla de contenido
loading

Tabla de contenido