Start Of Dishwasher - Sunbeam Products Oster OS-DWG12SS Manual De Instrucciones

NOTE: The maximum adjustment height of the feet is 20 mm.
How to Drain Excess Water from Hoses
If the sink is 1000mm higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or a suitable container
that is held outside and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks. Ensure
that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, observe to use a similar drain hose.
It must be no longer than 4 meters; otherwise, the cleaning effect of the dishwasher could be
reduced.
Syphon Connection
The waste connection must be at a height of between 50cm (minimum) and 100cm (maximum)
from the bottom of the dish. The water drain hose should be fixed by a hose clip.

Start of Dishwasher

The followings should be checked before starting the dishwasher:
1. Whether the dishwasher is level and fixed.
2. Whether the inlet valve is opened.
3. Whether there is leakage at the connections of the conducts.
4. Whether the wires are tightly connected.
5. Whether the power is switched on.
6. Whether the inlet and drain hoses are knotted.
7. All packing materials and printings should be taken out from the dishwasher.
Attention!
After installation, please put this manual into the bags of printings.
The content of this manual is very helpful to the users.
English-20